+# Lower Y limit of floatlands.
+# type: int
+# mgv7_floatland_ymin = 1024
+
+# Upper Y limit of floatlands.
+# type: int
+# mgv7_floatland_ymax = 4096
+
+# Y-distance over which floatlands taper from full density to nothing.
+# Tapering starts at this distance from the Y limit.
+# For a solid floatland layer, this controls the height of hills/mountains.
+# Must be less than or equal to half the distance between the Y limits.
+# type: int
+# mgv7_floatland_taper = 256
+
+# Exponent of the floatland tapering. Alters the tapering behaviour.
+# Value = 1.0 creates a uniform, linear tapering.
+# Values > 1.0 create a smooth tapering suitable for the default separated
+# floatlands.
+# Values < 1.0 (for example 0.25) create a more defined surface level with
+# flatter lowlands, suitable for a solid floatland layer.
+# type: float
+# mgv7_float_taper_exp = 2.0
+
+# Adjusts the density of the floatland layer.
+# Increase value to increase density. Can be positive or negative.
+# Value = 0.0: 50% of volume is floatland.
+# Value = 2.0 (can be higher depending on 'mgv7_np_floatland', always test
+# to be sure) creates a solid floatland layer.
+# type: float
+# mgv7_floatland_density = -0.6
+
+# Surface level of optional water placed on a solid floatland layer.
+# Water is disabled by default and will only be placed if this value is set
+# to above 'mgv7_floatland_ymax' - 'mgv7_floatland_taper' (the start of the
+# upper tapering).
+# ***WARNING, POTENTIAL DANGER TO WORLDS AND SERVER PERFORMANCE***:
+# When enabling water placement the floatlands must be configured and tested
+# to be a solid layer by setting 'mgv7_floatland_density' to 2.0 (or other
+# required value depending on 'mgv7_np_floatland'), to avoid
+# server-intensive extreme water flow and to avoid vast flooding of the
+# world surface below.
+# type: int
+# mgv7_floatland_ywater = -31000
+